Reliable plastic components for higher current power distribution equipment

Stanyl® offers high thermal resistance for internal and external components (housings)

For higher nominal current strength (In) and breaking capacity (Isc), meets short term thermal and magnetic tripping demands. Gives long-term reliability.
Resists melt-through from heat generated during overload breaking
For internal components, when high mechanical properties (strength, modulus, ductility) over a wide temperature range, up to >250º, need to be combined with high creep resistance as function of temperature.
For high In/Isc rated MCB flanges, good balance between resistance to part erosion and ability to generate gases that pre-cool the arc prior to entering arc extinguishing chamber

Dependable flammability and insulation resistance

UL yellow card data at low wall thicknesses
Consistent and reliable UL94 ratings even when high levels of regrind are used
Grades specifically tested according to and meeting IEC 695 GWFI
RTI ratings meeting application needs
Dependable and sufficient electrical properties (insulation, CTI)

High productivity material

Excellent moldability
- fast cycle times
- low T-mold
- low injection pressures
- outstanding flow to fill multi-cavity tools
Capable of molding to <1mm wall thickness while maintaining mechanical and electrical properties
Colorable for component identification and to comply with design needs
High regrind levels possible; yet maintain end-part performance

Stanyl® is the registered trademark of Royal DSM N.V.

Where Stanyl is used

MCB's with In > 40A and Isc >10-15kA
Internal parts e.g. tripping levers and bars, flanges,
Heat shields separating magnetic trip from other mechanisms
Thin wall bobbins

MCCB's for 85kA +
Internal parts e.g. tripping bars
Housing bases

Contactors according to IEC947-5/UL508
Moving contacts
Bases and housings
Thin wall bobbins

Stanyl grades can be readily marked

For printing key product information on components, Stanyl offers

best tampon printing adhesion
laser markable (UV or Nd-YAG laser types)

For detailed information on laser marking of DSM materials, more

Recommended Stanyl grades for LVSG applications

Housings and bobbins	Internals	Flanges
TE 250 F6	TW 200 F6	TW 341
TE 250 F8	TW 241 F10
TE 250 F9